Kidde SLED177I Návod k použití a péči stáhnout pdf

ATTENTION! The model SL177 and SL177i strobe lights are designed to notify hearing

impaired individuals of impending danger, they have no detection means and MUST be

used in conjunction with operating Smoke, Heat, or Carbon Monoxide Alarms.

The model SL177i AC wire-in Strobe light can be directly interconnected with Kidde

Safety 3-wire Smoke, Heat and CO alarms. It will produce an intermittent flash pattern

(approximately 4 flashes, followed by approximately 5 seconds off) when triggered by a

Carbon Monoxide alarm and a steady flash when triggered by a smoke or heat alarm.

The model SL177 is a 2-wire device that can be used to add strobe light capabilities to

existing alarm systems produced by other manufacturers. A relay module or suitable

switching device ( not included), which is compatible with the alarm system will be

needed to energize the strobe light. Consult the alarm manufacturer to obtain the prop-

er switching device for your specific alarm model.

Thank you for purchasing this strobe light. It is an important part of your family’s home

safety plan. You can trust KIDDE Safety to provide the highest quality safety products.

We know you expect nothing less when the lives of your family are at stake.

For models: SL 177i and SL 177

P/N 810-1779-EN Rev. B

1100-7210-00

Strobe

Light

For your convenience, write down the following information. If you call

our Consumer Hotline, these are the first questions you will be asked.

Strobe Light Model Number

(located on back of alarm):

Date Code (located on back of device):

Date of Purchase:

Where Purchased:

SL 177 SL 177i

Strobe Light User’s Guide

1100-7210-00(810-1779-EN B):_ 2011.2.17 4:27 PM Page 1

1 2 3 4 5 6 ... 13 14

Shrnutí obsahu

Strany 1 - Strobe Light User’s Guide

ATTENTION! The model SL177 and SL177i strobe lights are designed to notify hearingimpaired individuals of impending danger, they have no detection mea

Strany 2 - 1. SPECIFICATIONS

AFTER CLEANING, REINSTALL YOUR STROBE LIGHT AND TEST YOURSTROBE LIGHT BY ACTIVATING ONE OF THE CONTROLLING ALARMS.8. LIMITATIONS OF ALARM CONTROLLED V

Strany 3

9. GOOD SAFETY HABITSDEVELOP AND PRACTICE A PLAN OF ESCAPE• Install and maintain Fire extinguishers on every level of the home and in thekitchen, base

Strany 4 - 4. LOCATIONS TO AVOID

• Once outside, go to your selected meeting place and make sure everyone isthere.• Call the fire department from your neighbor’s home - not from yours

Strany 5 - 5. INSTALLATION INSTRUCTIONS

11. SERVICE AND WARRANTYIf after reviewing this manual you feel that your Visual Signaling Device is defec-tive in any way, do not tamper with the uni

Strany 6 - FIGURE 2

FIVE YEAR LIMITED WARRANTYKIDDE Safety warrants the original purchaser that the enclosed Visual signaling Devicewill be free of defects in material an

Strany 7

IMPORTANT! READ ALL INSTRUCTIONS BEFORE INSTALLATION AND SAVETHIS MANUAL FOR FUTURE REFERENCE WARNING! THIS VISUAL SIGNALING DEVICE HAS NO DETECTION

Strany 8

Multiple station (24) interconnect unit, interfaces directly with KiddeSafety:Ion Smoke Alarm Models: 1235, 1235CA, 1275, 1275CA, 1276, 1276CA, 1285,

Strany 9 - 7. MAINTENANCE

The following diagram shows that the light intensity gradually decreases as theviewing angle is increased. Use this information to determine the best

Strany 10

5. INSTALLATION INSTRUCTIONSREAD CAREFULLY – WIRING REQUIREMENTS• This smoke alarm should be installed on a U.L. listed or recognized junctionbox. All

Strany 11 - 9. GOOD SAFETY HABITS

5. Figure 1 illustrates interconnection wiring. Improper connection will result indamage to the strobe light or alarms, failure to operate, or a shock

Strany 12 - 10. NFPA REQUIRED PROTECTION

CONNECT 2-WIRE HARNESS.Figure 2 illustrates the proper SL177 wiring. Improper connection will result indamage to the strobe light or alarms, failure t

Strany 13 - 11. SERVICE AND WARRANTY

mount the ring, making sure that the mounting screws are positioned in thesmall ends of the keyholes before tightening the screws (see fig. 3).• Plug

Strany 14 - FIVE YEAR LIMITED WARRANTY

notification equipment interconnected with heat, smoke, or CO alarms in the liv-ing rooms, dining rooms, kitchens, hallways, attics, furnace rooms, cl

Komentáře k této Příručce

Žádné komentáře

Kidde SLED177I Návod k použití a péči

Procházejte online nebo si stáhněte Návod k použití a péči pro Detektory oxidu uhelnatého (CO) Kidde SLED177I. Kidde SLED177i Use and Care Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce